Use and Care Manual

4
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
• Remove the exterior and interior packing.
• Before connecting the wine cooler to the power source, let it stand upright for
approximately 4 hours. This will reduce the possibility of a malfunction in the cooling system from
improper handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth. (Cleaning instruction on page
11)
Installing Your Wine Cooler
• This wine cooler is designed to be free standing only, and should not be recessed or built-in.
• Allow 5 inches of space between the back and sides of the wine cooler, which allows the
proper air ventilation.
• Adjust the feet to keep the wine cooler level.
• Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Ambient temperature below 5°C or above 32°C will hinder the performance of this
appliance.
• Depending on the location of the appliance, the direction of the door opens can be changed.
• This unit is not designed for use in a garage or any other outside installation.
• Avoid locating the wine cooler in moist areas.
• Plug the wine cooler into dedicated, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
• This unit is not designed to be installed in an RV or used with an inverter.
• After plugging the wine cooler into a wall outlet, turn the unit on and allow the unit to cool
down for 3 ~ 4 hours under before placing wine bottles or beverages in the appliance.
Electrical Connection