Use and Care Manual

2
Operation
Storing Food
To get the best result from your appliance, follow these instructions:
1. Only store foodstuffs in the appliance when it has reached the correct operating temperature.
2. Do not place uncovered hot food or liquid inside the appliance.
3. Do not obstruct the fans inside the appliance.
Turn on
1. Close the door(s) of the appliance.
2. Ensure the power switch is set to [O] and turn on at the socket.
3. Switch on the power [l]. The current temperature within the appliance is displayed.
Cleaning, Care & Maintenance
·Switch off and disconnect from the power supply before cleaning.
·Clean the interior of the appliance as often as possible.
·Do not use abrasive cleaning agents. These can leave harmful residues.
·Clean the door seal with water only.
·Always wipe dry after cleaning.
·Take care when cleaning the rear of the appliance. Sharp edges can cut.
An agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser is mandatory and failure to do so will void the warranty.
We recommend that our agent or qualified technician clean the condenser.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to your dealer.
Fault Probable Cause Action
The appliance is not working
The unit is not switch on Check the unit is plugged in correctly and switched on
Plug and lead are damaged Call your agent or qualified technician
Fuse in the plug has blown Replace the fuse
Power supply Check power supply
Internal wiring fault Call your agent or qualified technician
The appliance turns on, but
the temperature is too
high/low
Too much ice on the evaporator Defrost the appliance
Condenser blocked with dust Call your agent or qualified technician
Doors are not shut properly Check doors are shut and seals are not damaged
Appliance is located near a heat source
or air flow to the condenser is being
interrupted
Move the refrigerator to a more suitable location
Ambient temperature is too high Increase ventilation or move appliance to a cooler position
Unsuitable foodstuffs are being stored
in the appliance
Remove any excessive hot foodstuffs or blockages to the fan
Appliance is overloaded Reduce the amount of food stored in the appliance
The discharge outside is blocked Clear the discharge outlet
Movement of water to the drain is
obstructed
Clear the floor of the appliance (if applicable)
The water container is damaged Call your agent or qualified technician
The drip tray is over flowing Empty the drip tray(if applicable)
The appliance is unusually
loud
Loose nut/screw Check and tighten all nuts and screws
The appliance has not been installed in
a level or stable position
Check installation position and change if necessary