Use and Care Manual

1
Safety Tips
l Position on a flat, stable surface.
l A service agent/qualified technician should carry out
installation and any repairs if required. Do not remove
any components or service panels on this product.
l Consult Local and National Standards to comply with
The following:
·Health and Safety at Work Legislation
·BS EN Codes of Practice
·Fire Precautions
·IEE Wiring Regulations
·Building Regulations
l DO NOT use jet/pressure washers to clean the appliance.
l DO NOT use the appliance outside.
l DO NOT use this appliance to store medical supplies.
l DO NOT use electrical appliances inside the appliance.
(e.g. heaters, ice-cream makers etc.)
l Always carry, store and handle the appliance in a
vertical position and move by holding the base of the
appliance.
l Always switch off and disconnect the power supply to
the unit before cleaning.
l Keep all packing away from children. Dispose of the
packaging in accordance with the regulations of local
authorities.
l If the power cord is damaged, it must be replaced by
an agent or a recommended qualified technician in
order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this
manual. Correct maintenance and operation of this
machine will provide the best possible performance from
your product.
We pride ourselves on quality and service, ensuring that at
the time of packing the contents are supplied fully functional
and free of damage.
Should you find any damage as a result of transit, please contact
your dealer immediately.
Installation
Note: If the unit has not been stored or moved in an upright
position, let it stand upright for approximately 12 hours before
operation. If in doubt allow the appliance to stand.
1. Remove the appliance from the packaging. Make
sure that all protective plastic film and coatings
are thoroughly removed from all surfaces.
2. Maintain a distance of 20cm (7 inches) between
the unit and walls or other objects for ventilation.
Increase this distance if the obstacle is a heat source.
Note: Before using the appliance for the first time,
clean the shelves and interior with soapy water.
3. Level the appliance by adjusting the screw feet.
Fit Glass Panels(optional)
1. Screw the collars to the rim of the appliance.
Note: Ensure the hole in the collar for the grub screw face
Inwards.
2. Slot the two side panels into the collars, with the holes in
The glass at the top.
Note: Ensure the screw hole furthest from the edge of the panel
goes to the back of the appliance.
3. Screw a grub screw into each collar to secure the panels.
Note: Ensure the soft end of the grub screw is the end making
contact with the glass.
4. Slot the rear panel into the collars, with the holes in the glass
at the top.
5. Screw a grub screw into each collar to secure the panel.
6. Slot the plastic plugs into each of the holes.
7. Screw the brackets to the inside of each pane using the bolt
assemblies.
Note: Ensure the short end of the bolt assembly is on the outside
of the panels.
8. Place the top panel onto the brackets, ensuring all holes line up.
9. Insert the plugs and attach the top panel to brackets with the bolt
assemblies.