Specification

ManualsBrandsKoolmore ManualsAppliances24 in. W 1.2 cu. ft. 1000-Watt Wall Mounted with Flat Bottom Microwave Drawer in Stainless Steel

INSTALLATION MANUAL

BUILT-IN STAINLESS STEEL

MICROWAVE DRAWER

MODEL:

KM-MD-1SS

MICROWAVE DRAWER

Intended for household use. Unit must be

kept clear of combustibles at all times.

For any service-related Issues, please contact

us: Phone Number: 718-576-6342

Email address: support@koolmore.com

Summary of content (5 pages)

PAGE 1
MICROWAVE DRAWER INSTALLATION MANUAL BUILT-IN STAINLESS STEEL MICROWAVE DRAWER MODEL: KM-MD-1SS Intended for household use. Unit must be kept clear of combustibles at all times. For any service-related Issues, please contact us: Phone Number: 718-576-6342 Email address: support@koolmore.
PAGE 2
Microwave Drawer INSTALLATION MANUAL SPECIAL WARNING INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE this installation manual FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. CLEARANCES AND DIMENSIONS For SAFETY CONSIDERATIONS do not install drawer in any combustible cabinetry, which is not in accord with the stated clearances and dimensions on pages 2 and 3. See Figure 1.
PAGE 3
CLEARANCES AND DIMENSIONS ·Dimensions that are shown in Figure 1 must be ·Check location where the Microwave Drawer will used. Given dimensions provide minimum clearance. Locate electrical outlet in the shaded area in the upper left-hand corner of the cutout. See Figure 3. ·Contact surface must be solid and level. Pay special attention to the floor on which the Microwave Drawer will sit.
PAGE 4
ANTI-TIP BLOCK ELECTRICAL OUTLET Suggested electrical outlet location Anti Tip block 5'' (6'') 31 2'' 4'' Figure 4 Figure 3 The electrical requirements are a 120 volt 60 Hz, AC only,l5 amp. or more protected electrical supply. It is recommended that a separate circuit serving only this appliance be provided. The drawer is equipped with a 3-prong grounding plug, It must be plugged into a wall receptacle that is properly installed and grounded.
PAGE 5
DRAWER INSTALLATION Mounting flange Figure 5 Screws 1. Place the drawer adjacent to the wall or cabinet opening.Plug the power supply cord into the electrical outlet. 2. Carefully guide the drawer into the prepared opening. Avoid pinching the cord between the oven and the wall. 3. Slide the drawer all the way until the mounting flange is flush with the face of the cabinet. See Figure 5. 4. Open the drawer. Using the 4 holes on the drawer as a template , pre drill the cabinet using a 1/16" bit.