Use and Care Manual

1. Before moving range, slide range onto shipping
base cardboard or hardboard.
2. Place the bracket on the floor with the back edge
against the rear wall. If the range does not reach
the rear wall, align the back edge of the bracket
with the rear panel of the range in its final
location.(See Figure 4)
REAR WALL Installation:
Use the 2 screws provided to secure the bracket
using the pair of marked holes at Loc C. The
screws MUST enter into a wood sill plate. If the
wall contains any metal studs or similar
materials, then the floor must be used.
6.
After installing the bracket, slide the
range into its final location. The rear leveling leg
must be fully inserted into the ANTI-TIP bracket
as shown in Step 2. To check if the bracket is
installed and engaged properly, look underneath
the range to see that the rear leveling leg is
engaged in the bracket. On some models, the
storage drawer or kick panel can be removed for
easier inspection. If visual inspection is not
possible, slide the range forward, confirm the
anti-tip bracket is securely attached to the floor or
wall, and slide the range back so the leveling leg
is under the anti-tip bracket. If the range is pulled
from the wall for any reason, always repeat this
procedure to verify the range is properly secured
by the anti-tip bracket.)
Figure 4
Figure 6
Figure 7
Figure 5
18
IMPORTANT: Determine the final location of the
range before attempting to install the bracket.
Contact a qualified floor covering installer for the
procedure of drilling mounting holes through
your type of floor covering.
Rear Wall
Loc C
Adjacent cabinet
or final location of
range side panel
Loc B
Loc A
3. Position the side of the bracket against either the
left or right cabinet. If there is no adjacent
cabinet, align the edge of the bracket with the
side panel of the range in its final location. If the
countertop overhangs the cabinet, offset the
bracket from the cabinet by the amount of
overhang.
4. Mark the location for the pair of holes to be used
(see Figure 4).
NOTE: For FLOOR installation use either Loc A
or B. For REAR WALL installation use Loc C.
5. The bracket must be screwed to either the
FLOOR or REAR WALL.
FLOOR Installation:
WOOD FLOOR: Use the screws provided to secure
the bracket using the pair of marked holes (either
Loc A or B).
CONCRETE FLOOR: Using a concrete bit, drill a
5/32” pilot hole 2” deep into
the concrete at the center of each of
the marked holes (either Loc A or B).
Use the screws provided to secure the bracket into
the floor.
If bracket does not touch the rear wall, you MUST
screw bracket to FLOOR as described in Step 5.
Bracket
Screw must enter
wood or concrete
Attachment to Floor or Rear Wall
Wall Sill Plate
Screw must enter wood
User Manual