Use and Care Manual

Unpack Range
Install Leveling Feet and Back Panel
Excessive Weight Hazard
Tip Over Hazard
A child or adult can tip the range and be killed.
Use two or more people to move and install range.
Failure to follow these instructions can result in death or serious burns to children and adults.
1.
Remove shipping materials from the range.
DO NOT remove protective film covering
the appliance. DO NOT remove tape
securing the drawer.
2. Remove oven racks and parts package
from inside oven.
3. Place range on its back; take four (4) L-
shaped cardboard corners from the carton.
Stack one cardboard corner on top of
another. Repeat with the other 2 corners.
4.
Place the four (4) L-shaped cardboard
corners lengthwise on the floor behind the
range to support the range when it is laid on
its back.
5.
Using 2 or more people firmly grasp the
range and gently lay it on its back on the
cardboard corners.
6.
Install the leveling feet one at a time. The
leveling feet can be found in one of the
boxes that was inside the oven.
7.
Place cardboard or hardboard in front of
range. Using 2 or more people, stand
range back up onto cardboard or
hardboard.
8. Remove the protective film covering the
appliance. Remove tape securing the
drawer.
9. The stainless steel back panel can now be
installed. Align backsplash holes with
holes at the edge of the stovetop, which
extends past the back of the oven.
16
Bottom
Edge
Back
Edge
10. With one person holding the backsplash
and working from underneath the
extended rear edge, insert screws through
the bottom of the backsplash. Tighten
completely.
11. Insert the two screws on each side,
through the back edge of the backsplash
and into the cooktop. Tighten completely.
User Manual