Use and Care Manual

8. Backsplash Assembly Instruction:

1. Open the package and remove the backsplash components.

2. Assemble the required components according to the upper figure.

3. Slide the back panel into the front panel from the bottom of the front panel.

4. Align the holes and use four pieces of #10 sheet metal screws to fasten the front and back

panels together firmly from the backside.

5. Insert the sliding panel support into the panel from the openings on top of the front panel,

align the holes, and use eleven pieces of #10 sheet metal screws to fasten them together firmly

from both the back and front.

6. Attach the cover to the front panel using four sets of M8 bolts and nuts,

making sure that the M8 nut is at the backside.

7. Assemble the cover support (for 60” only), and use a #10 sheet metal screw to fasten it firmly.

Cover

Cover Support (for 60” only)

Front Panel

Panel Support

Back Panel

#10 screw

M8 bolt

nut