Use and Care Manual

HEAT THERMOSTAT
The heat thermostat controls temperatures ranging from 80°F to 185°F. The dial is marked with numbers from 1
through 9, but these do not correspond to specific calibrated temperatures. Thus, optimal temperature settings
should be determined through personal familiarity with the unit's operations. The dial also includes an OFF position
to deactivate the heating unit.
HUMIDITY THERMOSTAT
The humidity thermostat enables you to control humidity levels ranging from 30% to 100%. As with the heat thermo-
stat, the dial is numbered from 1 through 9; these numbers do not correlate to specific humidity levels, so the best
settings should be determined through personal experience with the unit. The dial also features an OFF position for
deactivating the humidity function.
To maintain a low heat range between 85°F to 100°F, switch to proof mode and adjust the heat knob to the desired
heat range. Allow approximately 45 minutes for pre-heating in the proof cycle.
SERVICE SPECIFICATIONS
The Heater-Proofer is an aluminum transport cabinet, equipped with heaters to function as a hot food holding
cabinet and/or as a proofing cabinet.
The heater, or heat drawer, slides into place on the lower ledges of the cabinet. An electrical power cord is supplied
and is plugged into the drawer through an access hole in the cabinet's rear.
The main power switch, located on the front of the drawer, activates the internal light and the air-circulating fan
when switched ON. The circulating fan and the 1500W heater element operate continuously when the unit is ON.
Thermostat control knobs are positioned to the left and right of the HEAT/PROOF switch. The left knob controls the
cabinet's heat from 1 (approx. 30% relative humidity) to 9 (100% relative humidity). On average, the setting will be
around 6 (approx. 85% relative humidity).
GENERAL INFORMATION