Use and Care Manual

Installation and Operation
Operation:
• Before the first use, clean the inner surfaces and playing grids with a soft
cloth and a mild cleaning agent. Afterwards, thoroughly dry the device.
• Remove the water bowl from the device, which is installed inside, and then fill
it with water.
• Connect the device to a single grounded power socket.
• Set the required temperature for the respective foods. You can adjust the
desired temperature in the range between 30-90°C (86-194°F).
• The temperature inside the hot display can be read from the front display.
• Put the foods in appropriate containers before placing them inside the hot
display, and close it using the sliding door.
• Some parts of the device can become very hot. Always use safety gloves
when placing or removing foods.
• The foods are kept warm at the temperature you previously set.
• To place or remove foods, you can open the door at the rear side.
• Switch on the inner light as required using the device's light switch.
• Disconnect the device from the power socket when it is not in use.
Remember, safety should be your primary concern when operating this device.
Always handle hot elements with care and use gloves where necessary.
Installation:
• Position the device on a flat, stable surface that can adequately support the
device's weight and is not sensitive to heat.
• Avoid placing the device on an inflammable surface such as table cloths,
carpets, etc.
• Do not place the device near open fireplaces, electric ovens, arc furnaces,
electric heaters, or other sources of heat.
• Ensure that the device is positioned in a way that allows easy access to the
plug. This will make it easier for you to disconnect the appliance when needed.
Remember to always prioritize safety during installation and ensure you're following
all the instructions correctly. If you're unsure, it's best to seek professional help.
4