Manualshelf

Use and Care Manual

ManualsBrandsKoolmore ManualsAppliances12 cu. ft. Commercial Upright Freezer 2-Door Undercounter with Worktop in Stainless Steel
123456
on the nameplate of the unit. Please make sure that your unit has its
own dedicated outlet. Do not use an extension cord.
TEMPERATURE CONTROLS
The temperature controls are factory-set to maintain an average temperature
of 38 F in refrigerators and 0 F in freezers. To maintain a different temperature,
simply adjust the control knob located inside the unit.
To decrease the temperature (colder), turn clockwise. To increase
the temperature (warmer), turn counter-clockwise
CAUTION
Setting the temperature control to the coldest setting may cause the
evaporator coil to freeze and ice up. This will eventually result in a warmer
cabinet temperature.
LOADING PRODUCT
Shelves have been factory-installed for your convenience. Before loading shelves,
please be sure that all shelf clips are completely fastened in their correct
locations. It is important that all shelves rest completely level before stocking your
cabinet with product.
In order to maintain correct air flow inside the unit, please be sure to leave two
to four (2 to 4) inches of space between the back wall and stored product.
Blocking the evaporator fans will result in a warmer cabinet temperature, and
ultimately compressor failure.
DEFROST SYSTEMS
Refrigerator coils are kept below the freezing point (32 F). During compressor down-
time, the evaporator fan continues to circulate air through the evaporator coil. This
air circulation raises the coil temperature above the freezing point, melting any
accumulated frost. Run-off water is drained into the evaporator pan and evaporated.
Freezer coils are defrosted electrically. Automatic defrost timers are built-in to the
refrigeration system and may not be adjusted. The defrost timers automatically
initiate at pre-set intervals and for a pre-determined duration.
PLEASE NOTE: Excessive door openings should be avoided in order to maintain
cabinet temperature and to eliminate the possibility of coil freeze-up.
LOADING FOOD PANS
Pizza prep units and sandwich prep units are designed to function with all pans in