Specification

• Repair or replace immediately all power cords that have become frayed or
otherwise damaged. Do not use a power cord that has cracks or abrasion
damage along its length or at either of its ends.
• When removing the cooler away from the wall be careful not to run over or
damage the power cord.
NOTE: Wiring diagram can be referenced by removing the front louvered
grill, and looking on the inside cabinet wall.
Plug in the cooler and the compressor is ready to operate.
• Excessive tampering with the control could lead to service difficulties. Should
it ever become necessary to replace the temperature control it should be
ordered from your dealer or recommended service agent.
LIGHT SWITCH LOCATION:
The light switch is located at the left side of rear grille.
NOTE:
If the unit is disconnected or shut off, wait five (5) minutes before re-starting
unit.
RECOMMENDATION
Before loading product the unit should be run for 2 to 3 hours. This allows
confirmation that the electrical wiring and installation are correct and no
shipping damage has occurred.