User Manual

1. Use filtered water or tap water to supply the ice maker.
2. The pressure and temperature of the supply water must be 20 ~ 80 psi,
and 50 ℉~ 90℉, respectively.
3. Condensation may form on the door or on the drain hose and flow down to the floor.
4. Connect the water supply and drain hoses tightly to prevent any water leaks.
Warning
Installation
15
- Too high temperature of the ice-making water will decrease the amount of ice produced;
too low pressure will prevent ice from being made at all. Install an auxiliary pressure pump
in this case.
Appropriate water temperature Water pressure
Appropriate piping
/hose size
Ice making water supply 50 ~ 90 ℉
20 ~ 80 psi
3/8" FPT
Ice making water drain - -
3/4" FPT
Ice making water drain
(3/4" FPT)
Ice making water
supply inlet (3/8" FPT)
1. Unpacking the product
- Unpack the product and take out the parts packed inside the product.
2. Assembling the feet
- Assemble the 4 height adjustable feet on the bottom of the Ice Maker.
3. Level Adjustment
- Adjust the level of the machine with the height adjustable feet.
Lift the front side with the front feet so that the machine is inclined
slightly towards the rear.
(Make the front side higher than the rear side by 1/4-3/8")
4. Connect the water supply and drain hoses tightly to prevent water
leaks.