User Manual

Ice thickness control

There are three steps to adjust ice cube thickness.

The float switch is installed in 'Normal' mode at the factory .

There are 4 protruding

buttons on the water trough and 6 holes on the bracket.

To adjust the ice thickness, detach the float switch bracket from the water trough

and adjust per instructions below.

2. To make ice cube thinner or thicker, change the hole's location to move up or

down. (Please refer to the below picture)

To make thinner : Place float bracket into first 4 holes of the water

trough, last 2 holes remain open.)

To make thicker : Place float bracket into last 4 holes of the water

trough, first 2 holes remain open.)

Bracket float switch

NORMAL THICKTHIN