User Manual

Step 5. While the components are soaking into the solution, use a soft bristle brush to clean

ice zone surface of bin. Clean door interior, door rail, bin and evaporator mounting

bracket thoroughly and rinse them with clean water.

Step 6. Replace all removed parts after cleaning

Step 7. Set the switch to the WASH position to start automatic cleaning. Water is supplied

automatically.

Add 1.35oz of cleaner to the water trough.(Place the switch in the OFF

position when adding cleaner to the water

trough.)

Step 8. Wait until the cleaning cycle is complete(approximately 21 minutes) then place the

switch in the OFF position. Turn the switch back into the WASH position and

repeat the wash cycle if cleaner residue is still present in the water trough.

Step 9. Lime scale and mineral deposits should disappear when cleaning and rinsing is complete.

If foam is found in the water trough and the rinse is complete, repeat step 8

again.

Step 10. Step 10 is sanitization. This must be done once a month.

Soak all components from step 3 in a solution of 1.3 gallons of sanitizer

and water for 10 minutes to sanitize.

Pour solution over the larger parts. Rinse the parts thoroughly.

Use running tap water only for rinsing to prevent contamination.

Air dry parts, do not use a cloth or sponge.

Step 11. Use the solution of sanitizer and water and with a cloth or soft bristle brush

clean the ice zone surface of bin. Clean bin door, door rail, storage bin

and evaporator mounting bracket thoroughly and rinse with running tap

water to prevent contamination.

Step 12. Replace the parts. Place the switch in OFF position.

Step 13. Set the switch to WASH position to start automatic cleaning.

Water is supplied automatically.

Add 1.0oz of sanitizer to the water trough.

Step 14. Wait until the sanitization cycle is complete (approximately 21 minutes) then place

the switch in the OFF position. Turn the switch back to the WASH position

and repeat the sanitizing cycle while the sanitizer residue is still in the water

trough.

Step 15. Set the switch to the ICE position.The ice making cycle will begin.

Discard all ice made in the first cycle. Use ice made from

second cycle.