User Manual
22
/
Ice machine cleaner is used to remove lime scale and mineral deposits.
It cannot be used to remove algae and slime.
Refer to sanitization procedure on the following pages for removal of algae
and slime.
Mix 1 gallon of water and 21oz of sanitizer together in plastic or stainless steel container.
Step 1. Set the switch to the off position after the ice harvest cycle.
Or, set the switch to the off position and allow harvest cycle to finish
automatically.
Never use anything to force ice off the evaporator. Damage may result.
Step 2. Remove all ice from the bin. (Store in a proper container if wishing to reuse the ice)
Disconnect the power to ice machine at the circuit board before proceeding.
Step 3. Remove parts for cleaning.
① Open the bin door. Remove the sensors located on the front and side of the water
trough.
Disassemble the Ice damper, water trough and water distribution tube
by removing the screws.
Step 4. Soak all components into a solution of 1 gallon of cleaner and water mixture.
Use a nylon brush or cloth to clean the components thoroughly. Soak the parts
for 15~20 minutes for heavily scaled parts. Shake the parts occasionally.
Lukewarm water is preferred for cleaning. Rinse all parts and components
thoroughly with clean water.
Cleaner Water
150 ml (5.3 oz) 1 Qt
Sanitizer(5.25% Sodium Hypochlorite) Water
200 ml (7.05oz) 1.25 Qt