User Manual

19
Cleaning Method
1. Set the switch to OFF.
※ If the ice maker was in the ice making operation, it will
stop
after harvesting the current batch of ice cubes.
2. Unplug the power cord from the outlet.
3. Close the water valve.
4. Remove the two thumbscrews at the top rear of the
unit(see picture on right)remove the top cover and
then the door.
5. Remove the sensors from the front and side
of the water trough.
6. Remove 1 bolt on the right of the ice damper.
7. Remove 2 bolts on left and right and remove the water trough.
8. Remove the 2 bolts at the top to disassemble
water distribution cover.
9. Distill 3.5oz of mild dish washing detergent.
with 0.79 gal of warm water 93 ~ 113 ℉ and immerse
a clean cloth in the distilled solution to clean the area
behind where the water trough and the distribution cover
were removed.
10. Wash the water t
rough, water distribution cover and ice
damper with distilled mild detergent.
in trough.
ICE
OFF
WASH
High water
level sensor
Low water
level sensor
Bolt
Ice
damper
Water
tank
Water
distribution
cover