User Manual

24
25
Before Calling Service
If the ice maker operation is not in good status, check the following items.
If the symptom still persists, contact the purchased site.
Operation Status
1. The ice maker does
not operate.
1.Power is supplied?
2.The power switch is turned off?
3.The supplied power is within115 V±10%.
4.Is the ice bin full?
5.The ice damper is open?
6. The ambient temperature is below 50F
7.The ice maker is level?
8.The ice maker is contaminated?
9.The water filter is dirty?
1. The water supply valve is closed?
2. The water supply hose i s d amaged?
3. Water supply from city?
1. The water supply hose is blocked?
2. Water is not supplied.
3. The compressor properly operates?
4. Ventilation is restricted due to dust in the filter
on the front panel?
5. The condenser fan motor operates?
6. Is there any heat generator near the product?
7. The position of the drain hose is too low to supply enough water?
8. The ice made is too thin or thick?
9. The water in the water tank is not sufficient?
1.The ambient temperature of the installed
place is below 50F?
2.The supplied water is insufficient?
1. The floor is uneven or too weak to
handle the product?
1. Any foreign material in the drain hose?
1. Is water supplied into the water trough?
1. A small amount of water may flow into the ice bin.This is normal.
2. While the ice maker operates, a little vibration may be observed. This is normal.
1.Supply power.
2.Set the toggle switch to "ICE."
3.Check the power and use a dedicated outlet.
4.Remove ice to restart ice production.
5.Let the damper freely rotate for vertical movement.
6.The ambient temperature must be above 50F.
7.Adjust the level.
8.Perform cleaning and sterilization.
9.Change the water filter, part no. 141-0812
1. Open the water supply valve.
2. Repair if necessary.
3. Wait for reconnection of the water supply.
1.Remove foreign matter from the water supply.
2.After checking water pump,contact a technician.
3.After checking, contact the a technician.
4.Remove dust from the filter on the front panel
and perform cleaning.
5.After checking, contact a qualified technician.
6.Keep the product away from heat generator.
7.Adjust the height of the drain hose.
8.Adjust the ice thickness sensor.
9.Adjust the float level.
1. Make sure the floor is level and strong enough
to handle the weight of the ice maker.
1. Remove foreign material from the drain hose.
1.After installation, supply water for initial operation.
2.After cleaning, supply water for operation.
3.To operate the product again after clearing
water blockage,supply water for operation.
2. Water is not supplied.
3. The ice maker
operates but ice is
not made well.
(Ice non-forming)
4. The following cases
are not service issues.
5. The ice is too
frozen.
6. Noisy
7. Water is not draining
in the ice box.
8. The ice making is
not performing
correctly.
Check Item Solution
■Manufacturer :
www.icetro.com
78BL/ 3LT 2nd Namdong
Insdustrial Complex
Namdong-gu Incheon,
Korea
■Sales Agency :
Troubleshooting
If the ice maker is not operating correctly, check the following items. If the symptoms still
persist, contact the manufacturer or local service company.
1.Do not use the machine in the temperature less
than 50F.
2.When water is insufficient, supercooling may
follow.