User Manual

1. Removing the packaging

- After removing the cardboard outer box from the ice maker, remove

the provided parts from inside the ice maker.

2. Attaching the Feet

- Screw the feet into the bottom of the unit.

3. Adjusting the level

- By rotating the height controllers, adjust until the unit is level.

(Use the front feet)

4. Installing the water filter

Remove the plastic cap on the bottom right side of the ice maker and

install the filter.It is recommended that the filter be changed every six

months or sooner depending on your water quality.The ice maker will

stop working when the filter needs to be replaced.

Filter part number 141-0812, available from your dealer or the

manufacturer.

5. Connecting the water/drain hoses.

Connect the water hose to the 3/8" FPT connector and the drain hose

to the 3/4"FPT connector.

- Too high temperature of the ice-making water will decrease the amount of ice produced;

Too low pressure will prevent ice from being made at all. Install an auxiliary pressure pump in this case.

Ice making water drain

(3/4" FPT)

Ice making water

supply inlet (3/8" FPT)

Installing the Ice Machine

MPT

50-90F

20-80psi