Manual

Visit us at www.mvpgroupcorp.com . For customer questions email: [e-mail]
If the unit has been transported in a non-vertical position allow at least one hour before operating.
Remove all the packing material and tape, as well as any protective plastic from the equipment.
Remove bolts that secure the equipment to the pallet.
Remove any glue residue left over from the plastic or tape.
Clean the equipment before use. See the cleaning procedure in this document.
Clearance Requirements
Countertop cases require a minimum of 4” (10.2 cm) between the equipment and any walls surrounding
the unit. Surrounding walls
Installation
Place the equipment on a flat stable surface.
Plug the equipment into a properly grounded electrical supply matching the rating plate. Damage to the
equipment can occur if the incorrect power is supplied to the unit.
NOTICE: Using a voltage other than the nameplate rated voltage will cause damage to the unit. Incorrect voltage,
modification to the power cords or electrical components can the damage unit and will void the warranty.
After the installation is complete the thin breather wires on the top of the side glass panels may be
trimmed and crimped closed.
Unpack the Equipment
Countertop Model Installation