Owner manual
VMP3 Functional Description
ID 29230, Rev. 01 © 2005 Kontron Modular Computers GmbH Page 2 - 19
29230.01.UG.VC.050727/091426
P R E L I M I N A R Y
2.4.7.5 Monitor and Control Interfaces
The I/O expansion connector provides one MC signal: the MC4 which is an input and is used
as a
boot control signal. Low = boot from LPC device; high or open = boot from onboard
FLASH.
2.4.8 J12 In-System-Programming Interface
This programming interface supports in-system-programming of the VMP3 CPLD logic device.
The following figure and table provide pinout and signal information for this connector.
Figure 2-9: J12 In-System-Programming Connector
Table 2-16: Pinout of J12
SIGNAL PIN PIN SIGNAL
L_TCK 1 2 GND
L_TDO 3 4 +3V3
L_TMS 5 6 NC
NC 7 8 NC
L_TDI 9 10 GND
2
1
10
9