Owner manual

VMP3 Functional Description
ID 29230, Rev. 01 © 2005 Kontron Modular Computers GmbH Page 2 - 15
29230.01.UG.VC.050727/091425
P R E L I M I N A R Y
Table 2-11: Pinout of J9
SIGNAL PIN PIN SIGNAL SIGNAL PIN PIN SIGNAL
GND 1 2 SCL (I2C) AD17 51 52 AD16
RST# 3 4 +3.3V C/BE2 53 54 +5V
+3.3V 5 6 CLK1 GND 55 56 FRAME#
CLK2 7 8 GND IRDY# 57 58 GND
GND 9 10 NC +3.3V 59 60 TRDY#
INTB# 11 12 INTA# DEVSEL# 61 62 NC
INTD# 13 14 INTC# GND 63 64 STOP#
+5V 15 16 GNT1# LOCK# 65 66 +3.3V
GNT2# 17 18 +5V PERR# 67 68 +5V
+3.3V 19 20 NC SERR# 69 70 GND
GND 21 22REQ1# +5V 71 72PAR
REQ2# 23 24 GND C/BE1 73 74 AD15
+5V 25 26NC AD14 75 76+3.3V
AD31 27 28 AD30 GND 77 78 AD13
AD29 29 30 +5V AD12 79 80 AD11
GND 31 32AD28 AD10 81 82GND
AD27 33 34 AD26 GND 83 84 AD9
AD25 35 36 GND AD8 85 86 C/BE0
+3.3V 37 38 AD24 AD7 87 88 +5V
C/BE3 39 40 SDA (I2C) +3.3V 89 90 AD6
AD23 41 42 +3.3V AD5 91 92 AD4
GND 43 44 AD22 AD3 93 94 GND
AD21 45 46 AD20 NC 95 96 AD2
AD19 47 48 GND AD1 97 98 AD0
+5V 49 50 AD18 +12V 99 100 -12V
Note...
The PCI signalling voltage is 5V on this connector.