Instruction Manual

VMP1 VMP1-IO1 Module (Optional)

ID 19972, Rev. 0101Page A - 12 ® PEP Modular Computers GmbH

H Jumper Setting

The jumper settings of the IO1 module depend on the module’s position relative to the

VMP1 and other modules, if any (please see Figure A4 below).

Table A4: IO1 Jumper Settings for Different Module Positions

Figure A-4: Cascading of IO1 (or other) Modules onto the VMP1

IDSEL Clock GNT# REQ#

J12 J11 J10 J1 J2 J3 J4 J5 J6 J7 J8 J9

Position 1 Set Open Open Set Open Open Set Open Open Set Open Open

Position 2 Open Set Open Open Set Open Open Set Open Open Set Open

Position 3 Open open Set Open Open Set Open Open Set Open Open Set

Note:

Position 1 refers to the settings applicable when 1 module (IO1 or

other) is attatched to the VMP1.

Position 2 refers to the settings applicable when 2 modules (IO1

or other) are attatched to the VMP1.

Position 3 refers to the settings applicable when 3 modules (IO1

or other) are attatched to the VMP1.

Important!: Position 3 has not yet been tested and approved by

PEP and is not recommended for use in this issue of the manual.

KEY

: 1 additional module

P2: 2 additional modules

P3: 3 additional modules

P3 has not yet been tested and

approved by

PEP

and is intended

for possible future use.

VMP1

WU H

ABRST

LN K .

SPE EDAC T.

VMP1-IO1

or other

module

VMP1-IO1

or other

module

P1 P2 P3