Manual

VM62(A) / VM42(A) User’s Manual Chapter 3 Configuration

3.1.1 Jumper J1: VME-SYSCLK

Setting Description

Set SYSCLK connected to VME Default

Open SYSCLK disconnected from VME

3.1.2 Jumper J2: VME-SYSRES

Setting Description

Set On-board RESET generator to VME Default

Open On-board RESET disconnected from VME

3.1.3 Jumper J8: VME Boot (VBOOT)

Setting Description

Set Boot from VME enabled

Open Boot from VME disabled Default

3.1.4 Jumper J9: AutoBahn Boot (ABOOT)

Setting Description

Set Boot from MP memory interface enabled

Open Boot from MP memory interface disabled Default

3.1.5 Jumper J14: Connection of Protective and Signal GND

Setting Description

Set Signal GND connected to Protective GND

Note: Care must be taken to avoid grounding current if this jumper

is set.

Open Signal GND not connected to Protective GND Default