User guide

Hot Swap and Installation
15 RTM8050
www.kontron.com
3.2 RTMHDD Hot Swap and Installation
3.2.1 Installing the Hot Swap RTMHDD
To install the RTMHDD:
1 Carefully engage the RTMHDD into the guide. Push it until it fully mate with its connector. Secure
the hard disk handle to the locking position.
2 The blue LED shall turn ON as soon as the RTMHDD is fully inserted. It will turn OFF at the end of the
hot swap sequence.
3.2.2 Removing the Hot Swap RTMHDD
To remove the RTMHDD:
1 Pull out the handle to unlock the RTMHDD.
2 Wait for the blue LED to turn solid on (100% on).
3 Pull out the RTMHDD using the handle.