Owner's manual

PB-DOUT8
22 Oct 98
Configuration
Page 2 - 3Man. ID 17984, Rev. Index 0110
2. Configuration
2.1 Pinout
The PBDOUT-8 is connected via its carrier board to a 50-way flat-band cable or DSUB
connector. Depending on the carrier board location where the piggyback is installed (“A”
of “B”), either the upper half or the lower half of the connector pins are used
The following tables show the output registers and the corresponding output lines for the
upper (“A”) and lower (“B”) location, with reference to the relative DSUB/FB connectors
of the carrier board:
Table 2-1: PB-DOUT8 Pinout (Lower Position)
Pin DSUB 50 FB 50 Pin DSUB 50 FB 50
OUT07L Pin 1 Pin 1 OUT03L Pin 5 Pin 13
OUT07H Pin 34 Pin 2 OUT03H Pin 38 Pin 14
OUT06L Pin 18 Pin 2 OUT02L Pin 22 Pin 15
OUT06H Pin 2 Pin 4 OUT02H Pin 6 Pin 16
GND0607 Pin 35 Pin 5 GND0203 Pin 39 Pin 17
VSS0607 Pin 19 Pin 6 VSS0203 Pin 23 Pin 18
OUT05L Pin 3 Pin 7 OUT01L Pin 7 Pin 19
OUT05H Pin 36 Pin 8 OUT01H Pin 40 Pin 20
OUT04L Pin 20 Pin 9 OUT00L Pin 24 Pin 21
OUT04H Pin 4 Pin 10 OUT00H Pin 8 Pin 22
GND0405 Pin 37 Pin 11 GND0001 Pin 41 Pin 23
VSS0405 Pin 21 Pin 12 VSS0001 Pin 25 Pin 24