User Manual

CP6004X-SA Introduction
ID 1054-1227, Rev. 1.0 Page 1 - 11
D R A F T — F O R I N T E R N A L U S E O N L Y
Chipset
Intel® QM77 Mobile Intel® QM77 Express Chipset:
• Two x4 or eight x1 PCI Express 2.0 ports operating at 5 GT/s (only one
x2 and one x4 PCI Express ports are used on the CP6004X-SA)
• SATA host controller with six ports and RAID 0/1/5/10 support
• Two SATA 6 Gb/s ports accessible via onboard connectors
• Four SATA 3 Gb/s ports accessible via rear I/O
• USB 2.0 host interface with up to 14 USB ports available (only six ports
are used on the CP6004X-SA)
• USB 3.0 host interface with up to 4 USB ports available (not used on the
CP6004X-SA)
• Integrated Ethernet controller
• SPI flash interface support
• Low Pin Count (LPC) interface
• Power management logic support
• Enhanced DMA controller, interrupt controller, and timer functions
• System Management Bus (SMBus) compatible with most I²C™ devices
• DMI 2.0 with 5 GT/s and FDI interfaces to the processor
• High Definition Audio (HDA) interface
• Analog display port
• Three digital display ports
• Integrated RTC
Integrated
Controller
Graphics controller High-performance 3D graphics controller integrated in the processor:
• Supports analog displays (CRT) up to a resolution of 2048 x 1536
pixels with 32-bit color @ 75 Hz
• Supports digital displays (HDMI/DVI) up to a resolution of 1920 x
1200 pixels @ 60 Hz
• Dynamic Video Memory Technology (DVMT)
Interfaces
CompactPCI
Compliant with CompactPCI Specification PICMG
2.0 R 3.0:
• System controller operation
• 64-bit /66 MHz PCI or PCI-X master interface with dedicated PCIe-to-
PCI-X bridge
• 3.3V or 5V signaling levels (universal signaling support)
Compliant with the Packet Switching Specification PICMG 2.16.
The CP6004X-SA supports System Master hot swap functionality and applica-
tion-dependent hot swap functionality when used in a peripheral slot.
When used as a System Master, the CP6004X-SA supports individual clocks
for each slot and the ENUM signal handling is in compliance with the PICMG
2.1 Hot Swap Specification.
When installed in a peripheral slot, the CP6004X-SA is isolated from the Com-
pactPCI bus. It receives power from the backplane and supports rear I/O and,
if the system supports it, packet switching (in this case up to two channels of
Gigabit Ethernet).
Table 1-1: CP6004X-SA Main Specifications (Continued)
FEATURES SPECIFICATI ONS