User Manual

Introduction CP6004X-SA
Page 1 - 4 ID 1054-1227, Rev. 1.0
D R A F T — F O R I N T E R N A L U S E O N L Y
1.2 Board-Specific Information
The CP6004X-SA is a CompactPCI single-board computer based on the 3
rd
generation Intel®
Core™ i7 processor and specifically designed for use in highly integrated platforms with solid
mechanical interfacing for a wide range of industrial environment applications.
Some of the CP6004X-SA's outstanding features are:
• Support for the Intel® Core™ i7-3615QE (SV) quad-core processor, 2.3 GHz, 6 MB L3
cache
• Intel® QM77 Express Chipset
• Up to 16 GB, dual-channel, DDR3 SDRAM memory with ECC running at 1600 MHz on two
SODIMM sockets
• Integrated 3D high-performance graphics controller with three high-resolution graphics in-
terfaces (VGA, 2 x HDMI/DVI)
• 64-bit/66 MHz PCI or PCI-X CompactPCI interface (PICMG 2.0)
• One XMC slot utilizing a x8 lane PCI Express 2.0 interconnection
• Five Gigabit Ethernet interfaces:
• Three Gigabit Ethernet interfaces on front I/O
• Two Gigabit Ethernet interfaces on rear I/O (PICMG 2.16)
• Two Gigabit Ethernet (GbE) controllers:
• One Intel® 82579LM Gigabit Ethernet controller connected to one GbE port on the
front panel
• One Intel® I350 quad-port G ig abi t Et her ne t c on tr ol ler connected to two GbE ports on
the front panel and two GbE port s on the rear I/O
• Two 10 Gigabit Ethernet interfaces (10GBASE-KR) on the rear I/O (PICMG 2.20)
• One Intel® 82599 dual-port 10 Gigabit Ethernet controller
• Six SATA interfaces with SATA RAID 0/1/5/10 support:
• One onboard SATA 6 Gb/s interface for the standard SATA onboard connector
• One onboard SATA 6 Gb/s interface for either one SATA Flash module or one SATA
2.5" HDD/SSD
• Four SATA 3 Gb/s interfaces on the rear I/O
• Six USB ports:
• Two USB 2.0 ports on the front panel
• Four USB 2.0 ports on the rear I/O
• Two COM ports:
• One RS-232 COM port either on the front panel or on the rear I/O (COMA)
• One RS-232 COM port on the rear I/O (COMB)
• TCG 1.2 compliant Trusted Platform Module (TPM), on request
• Two SPI boot flashes for two separate uEFI BIOS images:
• One standard SPI boot flash
• One recovery SPI boot flash
• Watchdog timer
• Battery-backed real-time clock (RTC)
• Three onboard DIP switches for board configuration
• Supports PICMG Packet Switching Backplane Specification 2.16
• IPMI support
• 4HP, 6U CompactPCI
• Passive heat sink solution for forced-airflow cooling
• Rear I/O on J3 and J5
• High-speed interconnect serial rear I/O on J4 and J41 (PICMG 2.20)
• Hot swap capability: as system controller or as peripheral device
• AMI Aptio®, a uEFI-compliant platform firmware