Instruction Manual

Introduction CP6003-SA
Page 1 - 16 ID 1044-9757, Rev. 2.0
P R E L I M I N A R Y
1.6 Standards
The board complies with the requirements of the following standards:
Table 1-2: Standards
TYPE ASPECT STANDARD REMARKS
CE Emission EN55022
EN61000-6-3
--
Immission EN55024
EN61000-6-2
--
Electrical Safety EN60950-1 --
Mechanical Mechanical Dimensions IEEE1101.10 --
Environmental Climatic Humidity IEC60068-2-78 93% RH at 40°C, non-condensing
(see note below)
WEEE Directive
2002/96/EC
Waste electrical and electronic equipment
RoHS Directive
2002/95/EC
Restriction of the use of certain hazardous sub-
stances in electrical and electronic equipment
Vibration
(Sinusoidal)
IEC60068-2-6 Ruggedized version test parameters:
• 10-300 (Hz) frequency range
• 2 (g) acceleration
• 1 (oct/min) sweep rate
• 10 cycles/axis
• 3 axes
Single Shock IEC60068-2-27 Ruggedized version test parameters:
• 30 (g) acceleration
• 9 (ms) shock duration half sine
• 3 number of shocks per direction (total: 18)
• 6 directions
• 5 (s) recovery time
Permanent Shock IEC60068-2-29 Ruggedized version test parameters:
• 15 (g) acceleration
• 11 (ms) shock duration half sine
• 500 number of shocks per direction
• 6 directions
• 5 (s) recovery time