Instruction Manual

Introduction CP6003-SA
Page 1 - 12 ID 1044-9757, Rev. 2.0
P R E L I M I N A R Y
Interfaces
Rear I/O The following interfaces are routed to the rear I/O connectors J3 and J5.
• COMA (RS-232 signaling) and COMB (RS-422 signaling); no buffer on
the rear I/O module is necessary
• 4 x USB 2.0
• 1 x CRT VGA, 2 x HDMI/DVI
• 1 x HDA
• 2 x Gigabit Ethernet (compliant with PICMG 2.16, R 1.0)
• 4 x SATA 3 Gb/s
• 2 x GPIOs (on request)
The rear I/O connector J4 is optionally available and provides rear I/O inter-
connection to the PMC/XMC interface.
Gigabit Ethernet
Five 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on one Intel® 82579LM Gigabit Ethernet controller and one Intel®
82580EB Quad Gigabit Ethernet controller:
• Three RJ-45 connectors on the front panel
• Two ports on the rear I/O (PICMG 2.16)
• Automatic mode recognition (Auto-Negotiation)
• Automatic cabling configuration recognition (Auto-MDI/X)
USB
Six USB ports supporting UHCI (USB 1.1) and EHCI (USB 2.0):
• Two type A USB 2.0 connectors on the front panel
• Four USB 2.0 ports on the rear I/O interface
Serial Two 16C550-compatible UARTs:
• One RS-232 port on the front panel and routed to rear I/O, COMA
• One RS-422 port on the rear I/O, COMB
PMC PMC interface:
• Four onboard mezzanine connectors, (Jn1-Jn4), for connecting a stan-
dard PMC module
• Up to 64-bit/66 MHz PCI or up to 64-bit/133 MHz PCI-X interface with
dedicated PCIe-to-PCI-X bridge
• Only 3.3V PCI signaling voltage
• Rear I/O supported through the CompactPCI connector J4 (optional)
• Supported voltages: 3.3 V, 5 V, +12 V, and -12 V
XMC XMC interface:
• One onboard XMC connector (P15)
• Up to x8 lanes PCI Express 2.0 ports operating at 5 GT/s
• Rear I/O supported through the PMC connector (Jn4) to the
CompactPCI connector J4 (optional)
Serial ATA Two Serial ATA 6 Gb/s interfaces for:
• Up to 32 GB flash memory via an onboard SATA Flash module, or
• Onboard 2.5" hard disk drive (HDD) or solid state drive (SSD) is
supported in combination with the MMADP-SATA01 module
• One standard SATA 6 Gb/s interface for the standard SATA connector
Four SATA 3 Gb/s ports accessible via rear I/O
Table 1-1: CP6003-SA Main Specifications (Continued)
FEATURES SPECIFICATIONS