Manual

Boot Setup CP6003-SA/RA/RC uEFI BIOS
Page 28 ID 1045-9149, Rev. 2.0
P R E L I M I N A R Y
3.1.2 Bootup NumLock State
This function is used to set the state of the keyboard’s numlock function after POST.
Default setting: On
3.1.3 Quiet Boot
This function is used to display either POST output messages or a splash screen during boot-up.
Default setting: Disabled
3.1.4 CSM16 Module Version
This function provides display-only information concerning the CSM Module and is intended for
internal use only.
3.1.5 GateA20 Active
This function is used to enable or disable GateA20.
Default setting: Upon Request
3.1.6 Option ROM Messages
This function is used to control the messages of the loaded PCI option ROMs.
Default setting: Force BIOS
SETTING DESCRIPTION
On Use this setting to switch on the keyboard’s numlock function after POST.
Off Use this setting to switch off the keyboard’s numlock function after POST.
SETTING DESCRIPTION
Disabled Use this setting to display POST output messages during boot-up.
Enabled Use this setting to display a splash screen during boot-up.
SETTING DESCRIPTION
Upon Request Use this setting to disable GA20 in the uEFI BIOS.
Always Use this setting to prevent the system from disabling GA20.
SETTING DESCRIPTION
Force BIOS Use this setting to force to a BIOS-compatible output. This will show the option ROM mes-
sages.
Keep Current Use this setting to keep the current video mode. This will suppress option ROM messages.
Option ROMs requiring interactive inputs may not work properly in this mode.