User guide

CP6003-SA/RA/RC IPMI Firmware
ID 1045-5656, Rev. 2.0 Page 45
P R E L I M I N A R Y
The following figure illustrates the location of the two IPMI LEDs on the CP6003-RC.
The following table describes the functions of the IPMI LEDs and the Hot Swap LED.
Table 14: IPMI and Hot Swap LEDs Function
LED COLOR NORMAL MODE OVERRIDE MODE
I0 (right) red Off = board powered / running Selectable by user
Only lamp test
On = board out of service (frmware not running)
green Pulsing = traffic on the IPMB bus
I1 (left) red On = health error detected Selectable by user
Only lamp test
green Off = no health error detected
Pulsing = KCS interface active
Blinking = IPMI controller running showing its heart beat
red/amber Slow blinking = health error detected, IPMI controller running
showing its heart beat
Pulsing = health error detected, KCS interface active
HS LED blue On = a) board ready for hot swap extraction, or
b) board has just been inserted in a powered system
Off = board in normal operation (do not extract the board)
Blinking = board hot swap in progress; board not ready for
extraction
Selectable by user
Only lamp test
Temperature Sensor
JP1
DLED 0
DLED 1
DLED 2
DLED 3
R778 R756
R771 R759
IPMI LED I1
IPMI LED I0
IPMI LEDs
I0 and I1