Manual

The uEFI Shell CP6002 uEFI BIOS
Page 60 ID 1039-1612, Rev. 2.0
USAGE: Change IRQ
kipmi irq 10
Show IRQ configuration
kipmi irq
SETTINGS: fru [<FRU Device ID>]: Displays FRU data
Options:
FRU Device ID: Numeric FRU Device ID. 0 is assumed if FRU
Device ID is omitted. 0 is the baseboard’s own FRU Device ID.
info: Display IPMI firmware information
ipmb: Displays IPMB bus settings
ipmb dual-ported: Switch IPMB bus to dual-ported mode
ipmb single-ported: Switch IPMB bus to single-ported mode
irq <number>: Display/Set the IRQ number of the KCS interface
Options:
0: KCS uses no IRQ
10: KCS uses IRQ 10
11: KCS uses IRQ 11
The board must be reset for the settings to apply.
mode <mode>: Display/Set the IPMI controller operating mode
Options:
bmc: IPMI controller operates in BMC mode
smc: IPMI controller operates in SMC mode
net: Set Serial-over-LAN parameters
sel: Display system event log
sensor list|read: Show board sensor data
Options:
list: Display an overview of all available board sensors
read: Display specific sensor data
raw [<bytes> <...>]: Execute raw IPMI command
Syntax:
raw [NetFn] [LUN] [COMMAND] ...
Execute rawSendMessage command:
COMMAND / RESPONSE:
Shell> kipmi rawsendmessage 0x20 0x00 0x06 0x00 0x01
“kipmi rawsendmessage” alone returns error message and help on
available parameters
kipmi