Manual

The uEFI Shell CP6002 uEFI BIOS
Page 54 ID 1039-1612, Rev. 2.0
7.2.3 kboardinfo uEFI Shell Command
SETTINGS wr_prot_eeprom: System EEPROM write protection
[disabled]: Do not write protect the system EEPROM
enabled: System EEPROM is write-protected after POST
wr_prot_spi: EFI SPI flash write protection
[disabled]: Do not write protect the EFI SPI flash
enabled: The EFI SPI flash is write-protected after POST
CStates: Enable/Disable all CPU CStates ( [enabled] )
C1eState: Enable/Disable CPU C1eState ( [enabled] )
C3State: Enable/Disable CPU C3State ( [disabled] )
C6State: Enable/Disable CPU C6State ( [disabled] )
PciCfgDelay: Set Delay for PCI Configuration Cycle
[disabled]: No delay for PCI Configuration Cycle
1s, 2s, 3s, 4s or 5s: 1 to 5 seconds delay possible
VgaInterrupt: Enable/Disable VGA interrupt generation (assertion
of IGD interrupt signal) ( [disabled] )
kboardinfo
FUNCTION: Show board identification data
SYNTAX: kboardinfo
DESCRIPTION: The kboardinfo command shows a summary of board-specific
identification data. It is especially useful for support queries because it
contains this data in a concentrated form.
kboardconfig