Manual

CP6002 uEFI BIOS The uEFI Shell
ID 1039-1612, Rev. 2.0 Page 53
SETTINGS: pxe: Select PXE boot network adapter
disabled: No PXE boot available
[all]: Try all Ethernet devices round robin for PXE boot
front_a: Try only front port a for PXE boot
front_b: Try only front port b for PXE boot
rear_a: Try only rear port a for PXE boot
rear_b: Try only rear port b for PXE boot
Note: front_a corresponds to GbE A and front_b corresponds to
GbE B on the front panel of the CP6002.
StorageOrom: Launch Storage PCI Option ROMs
disabled: Do not launch storage PCI option ROMs. This includes the
onboard RAID option ROM.
[enabled]: Launch storage option ROMs, if present
HyperThreading: [Enable]/Disable Hyper-Threading Technology.
If this option is changed, a power cycle is required for it to take effect.
CpuTurbo: [Enable]/Disable CPU Turbo Boost Technology
PrimaryDisplay: Select primary display device
[auto]: Automatically detect primary display device
igd: Use internal graphics, if enabled
peg: Try to use video on the PCIe graphics port, if present
pci: Try to use video on the PCI(e) bus first
vga: VGA Port configuration
auto: Automatically detect devices. HDMI/DVI on Rear I/O
takes precedence over Front VGA if devices are
connected to both front and rear
[front]: Try to use Front-VGA if available.
rear: Try to use device connected to Rear I/O if available
disabled: Disable graphic output
SataMode: Determines how SATA controllers operate
[ide]: SATA ports operate as two IDE controllers
ahci: SATA ports operate as one 6-port AHCI controller
raid: SATA ports operate as one 6-port RAID controller
wr_prot_sata: Onboard SATA flash write protection
[disabled]: Do not write protect the onboard SATA flash
enabled: The onboard SATA flash is write-protected after POST.
NOTE: CONTACT KONTRON BEFORE USING THIS FUNCTION
kboardconfig