Owner manual

Kontron Modular Computers GmbH ID 31440, Rev. 01

P R E L I M I N A R Y

RevNr. = CP384 - 31440_01 - 060503/144230

Page 4 - 8

Configuration CP384

4.4 Programming Interface

4.4.1 Access Control Logic (Address Decoder)

All the resources of the CP384 are mapped within the 64 kB PCI memory address space which

itself is set in the PCI configuration register BAR0. The port size of all local or backend registers

is 32-bit by default. The address map of the registers is as follows.

Table 4-1: Backend Register Address Map

BASE ADDRESS

(BAR0)

SIZE FUNCTION

+ 0x0000 4 kB COMMON BOARD REGISTER

0x0400 32 bit g_irq General Interrupt Enable Register

0x0800 32 bit hsr Hardware Status Register

0x0804 32 bit i_pen General Interrupt Pending Register

0x0C00 32 bit hdr Hardware Debug Register

+ 0x1000 4 kB CAPABILITY ROM, SERIAL EEPROM

0x1000 32 bit r_cmd Command Register

0x1400 32 bit r_ctl Control Register

0x1800 32 bit r_sta Status Regsiter

0x1C00 32 bit r_dat Data Register

+ 0x2000 4 kB DIGOUT CLUSTER

0x2400 32 bit o_ctl_a Output Control Register

0x2800 32 bit o_sta_a Output Status Register

0x2C00 32 bit o_dat_a Output Data Register

+ 0x4000 4 kB DIGIN CLUSTER

0x4400 32 bit i_ctl Input Control Register

0x4408 32 bit i_irquen Input Irq Enable Register

0x440C 32 bit e_pol Input Event Polarity Register

0x4410 32 bit e_msk Input Event Mask Register

0x4414 32 bit e_len Input Latch-on Event Register

0x4418 32 bit c_cmp Input Pattern Compare Register

0x441C 32 bit c_msk Input Pattern Mask Register

0x4800 32 bit i_event Input Status Register

0x4C00 32 bit d_in Input Data Register

0x4C04 32 bit input Transparent Input Data

+ 0x5000 44 kB Reserved