Instruction Manual
CP372 Preface
ID 25780, Rev. 01 © 2002 Kontron Modular Computers GmbH Page v
25780.01.VC.021121/111236
P R E L I M I N A R Y
Chapter
4
4. Configuration ............................................................................................... 4 - 3
4.1 Jumper Settings ...................................................................................... 4 - 3
4.2 Analog Output Signal Requirements ....................................................... 4 - 3
4.2.1 Channels ......................................................................................... 4 - 3
4.2.2 Analog Voltage Output Signals ....................................................... 4 - 3
4.2.3 Analog Current Output Signals ....................................................... 4 - 4
4.2.4 External Cluster Enable/Disable ..................................................... 4 - 7
4.2.5 Analog Ground Usage .................................................................... 4 - 8
4.3 Programming Interface ............................................................................ 4 - 9
4.3.1 Access Control Logic ...................................................................... 4 - 9
4.3.2 DAC Control Logic ........................................................................4 - 10
4.3.3 Programming the Board Capability ROM ..................................... 4 - 11
4.3.4 Common Board Registers ............................................................ 4 - 13
Chapter
5
5. System Considerations ................................................................................ 5 - 3
5.1 Introduction ............................................................................................. 5 - 3
5.2 General ................................................................................................... 5 - 3
5.3 Shielding ................................................................................................. 5 - 3
5.4 Process-side Signal Conditioning ........................................................... 5 - 3
5.5 Cable Interfacing ..................................................................................... 5 - 4