Instruction Manual

CP372 Introduction
ID 25780, Rev. 01 © 2002 Kontron Modular Computers GmbH Page 1 - 9
25780.01.VC.021121/111236
P R E L I M I N A R Y
1.6 Technical Specifications
Table 1-3: CP372 Main Specifications
GROUP TYPE DESCRIPTION
DAC ProComm
Controller and
Related
FPGA Logic Device Provides PCI interfacing and IO control logic
Peripheral
Memory
CapROM 4 kBit (512 byte) EEPROM
External
Interfaces
Analog Output One, 62-pin, female, three row, D-sub connector
Supports up to eight analog output channels
CPCI Bus One, 132-pin, female, six row connector (standard CPCI type
connector for J1)
Internal Interfaces
JTAG/ISP JTAG/ISP 10-pin SMD connector for programming and testing
purposes
Indicators
Front Panel LED Two, green LED’s for indicating cluster operation status
(enabled or disabled)
General
Mechanical Conforms with IEEE 1101.1
Power Requirements Voltages: 3.3 V
5 V VCC
Power Consumption Watts: 0.5 W for the 3.3 V power source
2.9 W for the 5 V power source
Temperature Range Operational: 0ºC to +70ºC Standard
-40ºC to +85ºC E2
Storage: -55ºC to +125ºC
Humidity 0% to 95% non-condensing
Dimensions 100 mm x 160 mm single height Eurocard
Board Weight 155 g (2 cluster configuration)
Software Driver
Information
PCI Header Device ID: 0x5555
Vendor ID: 0x1556
Class Code: 0x118000
Subsystem Device ID: 0x0100
Subsystem Vendor ID: 0x1518
Note:
The Device ID and Vendor ID refer to the chip manufacturer. In
the Class Code value given, “11” relates to the data acquisition
and signal processing controllers and “8000” relates to the
Analog IO modules. Subsystem Device ID and Subsystem Ven-
dor ID are defined by PEP.
In addition, the CP372 uses 64kB in PCI memory space, BAR0,
is not pre-affectable, and no interrupts are used.