CP3003-SA/CP3003-V 3U CompactPCI Processor Board based on the 3rd Generation Intel® Core™ i7 Processor with the Intel® QM77 Chipset Doc. ID: 1052-6929, Rev. 2.0 July 29, 2013 If it’s embedded, it’s Kontron.
Preface CP3003-SA/CP3003-V Revision History DRAFT — FOR INTERNAL USE ONLY Publication Title: CP3003-SA/CP3003-V: 3U CompactPCI Processor Board based on the 3 rd Generation Intel® Core™ i7 Processor with the Intel® QM77 Chipset Doc. ID: 1052-6929 Rev. Brief Description of Changes Date of Issue 1.0 Initial issue 14-Nov-2012 2.
CP3003-SA Preface Revision History .........................................................................................................ii Imprint ........................................................................................................................ii Disclaimer ..................................................................................................................ii Table of Contents ..........................................................................................
Preface 2. CP3003-SA Functional Description ............................................................ 2 - 3 2.1 Processor .................................................................................................2 - 3 DRAFT — FOR INTERNAL USE ONLY 2.2 Memory ....................................................................................................2 - 4 2.3 Intel® QM77 Express Chipset .................................................................2 - 5 2.4 Timer ...................
CP3003-SA 2.11.9.6 Preface ENUM# Interrupt .................................................................. 2 - 16 2.11.10 CompactPCI Connectors J1 and J2 ............................................. 2 - 17 2.11.10.2 CompactPCI Connectors J1 and J2 Pinouts ........................ 2 - 18 2.11.10.3 Optional Rear I/O Interface .................................................. 2 - 21 2.11.10.4 Rear I/O Pin Description ...................................................... 2 - 24 3. Installation .....
DRAFT — FOR INTERNAL USE ONLY Preface CP3003-SA 4.2.5 Device Protection Register (DPROT) ..............................................4 - 8 4.2.6 Reset Status Register (RSTAT) .......................................................4 - 9 4.2.7 Board Interrupt Configuration Register (BICFG) ...........................4 - 10 4.2.8 Status Register 2 (STAT2) ............................................................. 4 - 11 4.2.9 Board ID High Byte Register (BIDH) .................................
CP3003-SA 6.2.2.2 6.2.3 Preface Clock Modulation .................................................................... 6 - 4 Catastrophic Cooling Failure Sensor ............................................. 6 - 4 6.4 External Thermal Regulation ................................................................... 6 - 5 A. 6.4.1 Operational Limits for the CP3003-SA .................................................6 - 6 6.4.2 Peripherals .................................................................
Preface C. CP3003-SA CP-RIO3-04 Rear I/O Module ................................................. C - 3 C.1 Overview ................................................................................................. C - 3 DRAFT — FOR INTERNAL USE ONLY C.2 Technical Specifications ......................................................................... C - 3 C.3 Front Panels ........................................................................................... C - 4 C.
CP3003-SA Preface 1-1 CP3003-SA Main Specifications ................................................................ 1 - 9 1-2 Standards ................................................................................................ 1 - 14 1-3 Additional Standards for Boards Ordered with Ruggedized Service ....... 1 - 15 1-4 Related Publications ................................................................................ 1 - 15 2-1 Features of the Processors Supported on the CP3003-SA ......
DRAFT — FOR INTERNAL USE ONLY Preface CP3003-SA 4-6 Control Register 1 (CTRL1) ....................................................................... 4 - 7 4-7 Device Protection Register (DPROT) ......................................................... 4 - 8 4-8 Reset Status Register (RSTAT) .................................................................. 4 - 9 4-9 Board Interrupt Configuration Register (BICFG) ...................................... 4 - 10 4-10 Status Register 2 (STAT2) ......
CP3003-SA Preface C-2 USB Con. J11 and J12 Pinout ................................................................... C - 6 C-3 D-Sub VGA Connector J7 Pinout .............................................................. C - 6 C-5 COM Connectors J2a (COMA) and J3a (COMB) Pinout ........................... C - 8 C-6 Serial Port Con. J2 (COMA) and J3 (COMB) Pinout ................................. C - 9 C-7 Peripheral Connector J13 Pinout ...............................................................
DRAFT — FOR INTERNAL USE ONLY Preface CP3003-SA This page has been intentionally left blank. Page xii ID 1052-6929, Rev. 2.
CP3003-SA Preface 1-1 CP3003-SA Functional Block Diagram .................................................... 1 - 6 1-2 4 HP CP3003-SA Front Panel ................................................................. 1 - 7 1-3 4 HP CP3003-SA Board Layout (Top View) ............................................. 1 - 8 1-4 4 HP CP3003-SA Board Layout (Bottom View) ....................................... 1 - 8 2-1 USB Connectors J5 and J6 ..................................................................
DRAFT — FOR INTERNAL USE ONLY Preface CP3003-SA B-1 CP3003-XMC Module Functional Block Diagram ................................... B - 4 B-2 Front Panel of the 8 HP CP3003-SA with CP3003-XMC Module ........... B - 5 B-3 CP3003-XMC Module Layout (Top View) ................................................ B - 6 B-4 CP3003-XMC Module Layout (Bottom View) .......................................... B - 6 B-5 CFast Connector J6 ..........................................................................
CP3003-SA Preface This document contains information proprietary to Kontron. It may not be copied or transmitted by any means, disclosed to others, or stored in any retrieval system or media without the prior written consent of Kontron or one of its authorized agents. The information contained in this document is, to the best of our knowledge, entirely correct.
Preface CP3003-SA Explanation of Symbols Caution, Electric Shock! DRAFT — FOR INTERNAL USE ONLY This symbol and title warn of hazards due to electrical shocks (> 60V) when touching products or parts of them. Failure to observe the precautions indicated and/or prescribed by the law may endanger your life/health and/or result in damage to your material. Please refer also to the section “High Voltage Safety Instructions” on the following page.
CP3003-SA Preface Your new Kontron product was developed and tested carefully to provide all features necessary to ensure its compliance with electrical safety requirements. It was also designed for a long fault-free life. However, the life expectancy of your product can be drastically reduced by improper treatment during unpacking and installation.
Preface CP3003-SA DRAFT — FOR INTERNAL USE ONLY General Instructions on Usage In order to maintain Kontron’s product warranty, this product must not be altered or modified in any way. Changes or modifications to the device, which are not explicitly approved by Kontron and described in this manual or received from Kontron’s Technical Support as a special handling instruction, will void your warranty.
CP3003-SA Preface Kontron grants the original purchaser of Kontron’s products a TWO YEAR LIMITED HARDWARE WARRANTY as described in the following. However, no other warranties that may be granted or implied by anyone on behalf of Kontron are valid unless the consumer has the express written consent of Kontron. Kontron warrants their own products, excluding software, to be free from manufacturing and material defects for a period of 24 consecutive months from the date of purchase.
DRAFT — FOR INTERNAL USE ONLY Preface CP3003-SA This page has been intentionally left blank. Page xx ID 1052-6929, Rev. 2.
Introduction Chapter 1 Introduction ID 1052-6929, Rev. 2.
DRAFT — FOR INTERNAL USE ONLY Introduction CP3003-SA This page has been intentionally left blank. Page 1 - 2 ID 1052-6929, Rev. 2.
1. Introduction 1.1 Board Overview Introduction The CP3003-SA is a highly integrated 3U, 4 HP CompactPCI system controller board optionally expandable to 8 HP and available either as a front I/O version or as a rear I/O version. It has been designed to support the multi-chip package, 3rd generation Intel® Core™ i7 processor combined with the mobile Intel® QM77 Express Chipset. The board supports the Intel® Core™ i7-3612QE quad-core processor with 2.
DRAFT — FOR INTERNAL USE ONLY Introduction CP3003-SA Some of the CP3003-SA's outstanding features include: • Support for the following 3rd generation processors: • Intel® Core™ i7-3612QE (SV) quad-core processor, 2.1 GHz, 6 MB L3 cache • Intel® Core™ i7-3555LE (LV) dual-core processor, 2.5 GHz, 4 MB L3 cache • Intel® Core™ i7-3517UE (ULV) dual-core processor, 1.
1.3 System Expansion Capabilities 1.3.1 CP3003-HDD Module (8 HP and 12 HP) Introduction The CP3003-HDD module for the 8 HP CP3003-SA version provides various I/O ports. On the front panel, it includes two DisplayPort connectors, one Gigabit Ethernet port, one USB 3.0 port, and one RS-232 COM port. Onboard ports include one SATA connector for SATA 2.5” HDD or SSD devices as well as a CFast card socket.
Page 1 - 6 USB 2.0 Type A USB 2.0 Type A USB USB Watchdog / Thermal LEDs POST Code / Debug / Gen. Purpose LEDs DSUB 15-pin RJ-45 GbE VGA CRT RJ-45 LPC COMA+B XBUS COMA To Rear I/O CPLD VGA Mux GbE Contr. GbE Switch Rear I/O Eth GbE Contr. GbE Switch Rear I/O Eth Dual UART PCIe x8 Debug TPM HighSpeed I/O Extension Connector VGA CRT 2x USB 2.
CP3003-SA 1.4.2 Introduction Front Panel Watchdog and Overtemperature Status LEDs CP3003 WD (green): TH (red/green): Watchdog Status Overtemperature Status Integral Ethernet LEDs ACT (green): SPEED (green/orange/off): Ethernet Link/Activity Ethernet Speed General Purpose LEDs LED0..3 (red/green/red+green): General Purpose/POST Code Note ... USB 2.0 If the General Purpose LEDs 0..3 are lit red during boot-up, a failure is indicated before the uEFI BIOS has started. GbE A GbE B Note ...
Introduction 1.4.3 CP3003-SA Board Layout DRAFT — FOR INTERNAL USE ONLY Figure 1-3: 4 HP CP3003-SA Board Layout (Top View) DDR3 SODIMM Sockets Ch. A 1 2 J11 9 10 1 J3 Ch.
CP3003-SA Technical Specification Table 1-1: CP3003-SA Main Specifications FEATURES The CP3003-SA supports the following 3 rd generation microprocessors: • Quad-core Intel® Core™ i7-3612QE (SV), 2.1 GHz, 6 MB L3 cache • Dual-core Intel® Core™ i7-3555LE (LV), 2.5 GHz, 4 MB L3 cache • Dual-core Intel® Core™ i7-3517UE (ULV), 1.
Introduction Table 1-1: CP3003-SA CP3003-SA Main Specifications (Continued) SPECIFICATIONS High-performance 3D graphics controller integrated in the processor: • Dynamic Video Memory Technology (DVMT) • Supports digital displays with resolutions up to 2560 x 1600 pixels @ 60 Hz through DisplayPort or up to 1920x1200 pixels @ 60Hz using HDMI/DVI. HDMI/DVI displays are supported via an appropriate adapter. Refer to Chapter 2.11.4, Table 2-8 for further information on the display configuration options.
CP3003-SA CP3003-SA Main Specifications (Continued) FEATURES Gigabit Ethernet SPECIFICATIONS Three 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces based on three Intel® 82574L Ethernet PCI Express bus controllers, two interfaces individually switchable to front I/O or rear I/O, one interface available on the CP3003-HDD module: • • • • USB Dual RJ-45 connector on the front panel Automatic mode recognition (Auto-Negotiation) Automatic cabling configuration recognition (Auto-MDI/X) Wake-on-L
Introduction Table 1-1: CP3003-SA CP3003-SA Main Specifications (Continued) Front Panel Connectors • VGA: 15-pin D-Sub connector, J4 • USB: two 4-pin, type A connectors, J5 and J6 • Ethernet: dual RJ-45 connector, J7A/B Onboard Connectors • • • • • • • • • Sockets Switch SPECIFICATIONS 7-pin, L-form standard SATA connector, J3 120-pin, high-speed I/O extension connector, J14 60-pin, high-speed PCI Express extension connector, J8 SPI extension connector, J11 18-pin extension connector for the SATA
CP3003-SA CP3003-SA Main Specifications (Continued) FEATURES SPECIFICATIONS AMI Aptio®, AMI’s next-generation BIOS firmware based on the uEFI Specification and the Intel Platform Innovation Framework for EFI.
Introduction 1.6 CP3003-SA Standards This product complies with the requirements of the following standards. DRAFT — FOR INTERNAL USE ONLY Table 1-2: Standards TYPE CE ASPECT STANDARD Emission EN55022 EN61000-6-3 Immission EN55024 EN61000-6-2 Electrical Safety EN60950-1 Mechanical Mechanical Dimensions IEEE 1101.
CP3003-SA Introduction In addition, boards ordered with the ruggedized service comply with the following standards as well. Additional Standards for Boards Ordered with Ruggedized Service TYPE ASPECT Environmental 1.
DRAFT — FOR INTERNAL USE ONLY Introduction CP3003-SA This page has been intentionally left blank. Page 1 - 16 ID 1052-6929, Rev. 2.
