Instruction Manual

CP3003-SA/CP3003-V uEFI BIOS The uEFI Shell
ID 1053-4014, Rev. 2.0 Page 57
D R A F T — F O R I N T E R N A L U S E O N L Y
6.2.10 kresetconfig uEFI Shell Command
kresetconfig
FUNCTION: Control the board reset behavior
SYNTAX: kresetconfig [-?] <parameter>
where:
-? Show help
<parameter> pcislave [on|off]
Controls if the board shall react on a CPCI backplane
reset if it is used as slave board in a peripheral slot. It
has no effect if the board is located within a CPCI mas-
ter slot.
Note: This parameter is volatile and at next start is set
to off.
DESCRIPTION: The kresetconfig command controls the board’s reset behavior.
USAGE: Enable cPCI backplane reset:
COMMAND / RESPONSE EXAMPLE:
Shell> kresetconfig pcislave on
Reset from system master is enabled
Disable cPCI backplane reset:
COMMAND / RESPONSE EXAMPLE:
Shell> kresetconfig pcislave off
Reset from system master is disabled