Instruction Manual

Security Setup CP3003-SA/CP3003-V uEFI BIOS
Page 32 ID 1053-4014, Rev. 2.0
4.1 Administrator Password
This function is used to set, change or delete the Administrator password. If there is already a
password installed, the system asks for this first. To clear a password, simply enter nothing and
acknowledge by pressing Return. To set a password, enter it twice and acknowledge by press-
ing Return.
Note: The password is case sensitive.
4.2 User Password
This function is used to set, change or delete the User password. If there is already a password
installed, the system asks for this first. To clear a password, simply enter nothing and acknowl-
edge by pressing Return. To set a password, enter it twice and acknowledge by pressing Re-
turn.
Note: The password is case sensitive.
4.3 HDD Security Configuration
Allows access to set, modify and clear the harddisk User password. The harddisk User pass-
word must be set to enable harddisk security.
Note: This function is only available if a HDD/SSD is detected which supports this function.
Note: The harddisk User password is case sensitive.
4.4 Remember the Password
It is highly recommended to keep a record of all passwords in a safe place. Forgotten pass-
words may lead to being completely locked out of the system.
If the system cannot be booted because neither the uEFI BIOS User password nor the Admin-
istrator password are known, refer to the CP3003-SA/CP3003-V User Guide, Chapter 4.1, for
information about clearing the uEFI BIOS settings, or contact Kontron for further assistance.
Note: The harddisk User password cannot be cleared using the above method.