User Manual

CP3002-RC/CP3002-RA Introduction
ID 1039-3625, Rev. 1.0 Page 1 - 9
P R E L I M I N A R Y
Integrated
Controller
Graphics controller High-performance 3D graphics controller integrated in the processor:
• Supports resolutions up to 2048 x 1536 pixels @ 60 Hz
• Dynamic Video Memory Technology (DVMT)
Interfaces
CompactPCI
Compliant with CompactPCI Specification PICMG
2.0 R 3.0:
• System controller operation
• 32-bit, 33/66 MHz PCI master interface with dedicated PCIe-to-PCI
bridge
• 3.3 V or 5 V signaling levels (universal signaling support)
• Support for up to four peripheral slots (4x REQ/GNT signals)
Rear I/O The following interfaces are routed to the rear I/O CompactPCI connector J2:
• 1 x COMA (RS-232 signaling)
• 1 x COMB (RS-422/RS-232 signaling)
• 2 x USB 2.0
• 1 x VGA analog port
• 4 x 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
• 2 x SATA
• 5 x GPIs and 3x GPOs (LVTTL signaling)
• Back-up voltage (3.3 V)
Interfaces
Gigabit Ethernet
Up to four 10 Base-T/100 Base-TX/1000 Base-T Gigabit Ethernet interfaces
based on the Intel® 82580EB Quad Gigabit Ethernet controller:
• Four ports on the rear I/O
• Automatic mode recognition (Auto-Negotiation)
• Automatic cabling configuration recognition (Auto-MDI/X)
USB
Two USB 2.0 ports on the rear I/O interface
Serial Two 16C550-compatible UARTs (RS-232/RS-422 signaling):
• One RS-232 port on the rear I/O, COMA
• One RS-422/RS-232 port on the rear I/O, COMB
Serial ATA Serial ATA Host Controllers integrated in the Intel® QM57 chipset:
• Provide support for three SATA ports, one onboard and two on rear I/O
• Data transfer rates up to 300 MB/s
• High-performance RAID 0/1/5 functionality on all SATA ports
Sockets
Onboard Connectors • One 34-pin extension connector, J3, for SATA Flash module (SSD)
• JTAG connector, J4
• XDP-SFF (debug) connector, J6
• CompactPCI Connectors J1 and J2
LEDs
Debug LEDs Debug LEDs:
• DLED0-3 (red/green): Onboard LEDs for debugging purposes
The DLEDs are located on the rear side of the board.
On the CP3002-RA, the DLEDs are visible on the front panel.
Table 1-1: CP3002-RC/CP3002-RA Main Specifications (Continued)
FEATURES SPECIFICATIONS
Note ...
To operate the CP3002-RC/CP3002-RA, 3U CompactPCI back-
plane with maximum five slots and rear I/O support on the system
slot is required.