Instruction Manual
CP-RIO6-001-HD-VGA Functional Description
ID 1052-4138, Rev. 1.0 Page 2 - 15
2.1.8 GPIO Connectors J10 and J11
The CP-RIO6-001-HD-VGA has two GPIO interfaces, one on J10 (GPIO:0) and one on J11
(GPIO:1). Pin 1 is the signal and pin 2 is ground. Refer to figure 1-3 for the connector locations
and pin orientation.
Signal direction, input or output and voltage leveling is a function of the CPU. Filtering and
signal protection must be done by the system integrator.
2.2 System Write Protection Jumper J12
When set, this jumper signals the host CPU to invoke system write protection. If this protection
is required, please contact Kontron before implementing.
The default setting is indicated by using italic bold.
Table 2-14: J12 Jumper Setting for System Write Protection
J12 DESCRIPTION
Open System Write Protection not enabled
Closed System Write Protection enabled