Instruction Manual

Functional Description CP-RIO6-001-HD-VGA
Page 2 - 8 ID 1052-4138, Rev. 1.0
2.1.4.2 SATA Connector J15
The CP-RIO6-001-HD-VGA rear I/O module is equipped with the SATA connector J15 used to
connect a 2.5” SATA HDD/SSD to the rear I/O module. The connector is divided into two seg-
ments, a signal segment and a power segment.
Figure 2-6: SATA Connector J15
Table 2-6: SATA Connector J15 Pinout
PIN SIGNAL FUNCTION I/O
Signal Segment Key
S1 GND Ground signal --
S2 SATA_TX+ Differential Transmit+ I
S3 SATA_TX- Differential Transmit- I
S4 GND Ground signal --
S5 SATA_RX- Differential Receive- O
S6 SATA_RX+ Differential Receive+ O
S7 GND Ground signal --
Signal Segment “L”
Central Connector Polarizer
Power Segment “L”
P1 3.3V 3.3V power --
P2 3.3V 3.3V power --
P3 3.3V 3.3V power --
P4 GND Ground signal --
P5 GND Ground signal --
P6 GND Ground signal --
P7 5V 5V power --
P8 5V 5V power --
P9 5V 5V power --
P10 GND Ground signal --
P11 RES Reserved --
P12 GND Ground signal --
P13 12V 12 V power --
P14 12V 12 V power --
P15 12V 12 V power --
Power Segment Key
Signal
Segment
Power
Segment
S1
S7
P1
P15