Instruction Manual

Functional Description CP-RIO6-001-HD-VGA
Page 2 - 6 ID 1052-4138, Rev. 1.0
2.1.3 Gigabit Ethernet Interfaces
The CP-RIO6-001-HD-VGA provides a Gigabit Ethernet interface implemented as one dual,
RJ-45 Ethernet connector J18A/B.
Ethernet LED Status
ACT (green): This LED monitors network connection and activity. When this LED is lit, it means
that a link has been established. The LED blinks when network packets are sent or received
through the RJ-45 port. When this LED is not lit, there is no link established.
LINK (green): This LED lights up to indicate a successful 100Base-TX connection. When not
lit and the ACT-LED is active, the connection is operating at 1000Base-T or 10Base-T.
Note ...
The Ethernet transmission can operate effectively with structured cable that
meets CAT5 cable or higher specifications.
Figure 2-4: Dual Gigabit Ether-
net Con. J18A/B
J18B
J18A
8
1
8
1
Table 2-4: Pinout of Dual GbE Connector J18A/B
PIN
MDI / STANDARD ETHERNET CABLE
10BASE-T 100BASE-TX 1000BASE-T
I/O SIGNAL I/O SIGNAL I/O SIGNAL
1 O TX+ O TX+ I/O BI_DA+
2 O TX- O TX- I/O BI_DA-
3 I RX+ I RX+ I/O BI_DB+
4----I/OBI_DC+
5----I/OBI_DC-
6 I RX- I RX- I/O BI_DB-
7----I/OBI_DD+
8----I/OBI_DD-