Instruction Manual

CP-RIO6-001-HD-VGA Functional Description
ID 1052-4138, Rev. 1.0 Page 2 - 5
2.1.2 VGA Interface
The CP-RIO6-001-HD-VGA provides one 15-pin, female connector, J20, on the front panel.
This connector is used to connect an analog VGA (CRT) monitor to the module.
The following figure illustrates the D-Sub VGA connector J20.
Figure 2-3: D-Sub VGA Connector J20
The following table indicates the pinout of the D-Sub VGA connector J20
.
Table 2-3: D-Sub VGA Connector J20 Pinout
PIN SIGNAL FUNCTION I/O
1 Red Red video signal output O
2 Green Green video signal output O
3 Blue Blue video signal output O
4 NC Not connected --
5 - 8 GND Signal ground --
9 VCC Power +5V, 0.5 A fuse protection O
10 GND Signal ground --
11 NC Not connected --
12 SDA I²C data (EDID) I/O
13 Hsync Horizontal synchronization TTL Out
14 Vsync Vertical synchronization TTL Out
15 SCL I²C clock (EDID) I/O
1
6
11
15
10
5