Instruction Manual

Introduction CP-RIO6-001-HD-VGA

Page 1 - 6 ID 1052-4138, Rev. 1.0

1.3 Technical Specification

Table 1-1: CP-RIO6-001-HD-VGA Main Specifications

CP-RIO6-001-HD-VGA SPECIFICATIONS

Front Panel

Interfaces

Analog Video VGA: 15-pin, D-Sub connector, J20

Ethernet Two Gigabit Ethernet interfaces implemented as a dual RJ-45 connector,

J18A/B

USB Two USB 2.0 interfaces on type A connectors, J16 and J17

COM One COM interface implemented as a single RJ45 connector, J19

Onboard Interfaces

SATA Two SATA interfaces implemented as two onboard connectors:

• One SATA connector, J13, for connecting a SATA device via a

SATA cable

• One SATA connector, J15, for installing an optional 2.5” SATA

HDD/SSD

USB One onboard connector, J14, for connecting one USB 2.0 NAND Flash

module

COM One COM port implemented as one 10-pin, 2.54 mm onboard connector,

Fan Two fan connectors, J6 and J7, with sense inputs for monitoring the fan

speed

CompactPCI Three CompactPCI connectors, rJ3, rJ4 and rJ5, for connecting the mod-

ule to the backplane

GPIO Two GPIO interfaces on the two-pin connectors J10 and J11

General

Temperature Range Operational: 0°C to +60°C Standard

-40°C to +85°C E2 (optional)

Storage: -55°C to +85°C Without any additional components

Mechanical 6U, 4HP, CompactPCI-compliant form factor

Dimensions 233.35 mm x 80 mm

Board Weight 228 g (without USB NAND Flash module and/or HDD/SSD)

Note ...

When additional components are installed, refer

to their operational specifications as this will influ-

ence the modules’ operational and storage tem-

perature.