Manual

Introduction CP-RIO3-05
Page 1 - 6 ID 1044-0711, Rev. 1.0
P R E L I M I N A R Y
1.3 Technical Specification
Table 1-1: CP-RIO3-05 Main Specifications
CP-RIO3-05 SPECIFICATIONS
Front Panel
Interfaces
VGA One VGA interface on a 15-pin, D-Sub connector, J8, for connecting a
standard analog monitor
Ethernet Four Gigabit Ethernet interfaces implemented as two dual RJ-45 connec-
tors, J6 (ETH A / ETH B) and J7 (ETH C / ETH D)
COM Two serial ports:
• COM1, RS-232, implemented as a 9-pin, D-Sub connector, J2a
• COM2, RS-232/RS-422, implemented as a 9-pin, D-Sub connec-
tor, J3a
Onboard
Interfaces
SATA Two SATA II interfaces (with SATA II repeater) implemented as two
onboard connectors, J4 and J5, for connecting external SATA devices via
a SATA cable
COM Two serial ports:
• COM1, RS-232, implemented as a 10-pin connector, J2
• COM2, RS-232/RS-422, implemented as a 10-pin connector, J3
The onboard serial port connectors, J2 and J3, are connected to the front
panel COM connectors, J2a and J3a, via flat cables.
GPIO One 10-pin general purpose I/O connector, J10, with the following fea-
tures:
• Five general purpose inputs
• Three general purpose outputs
CompactPCI One CompactPCI connector, rJ2, for connecting the CP-RIO3-05 to the
backplane
General
Temperature Range Operational: -40°C to +70°C
Storage: -55°C to +85°C Without any additional components
Mechanical 3U, 8HP, CompactPCI-compliant form factor
Dimensions 100 mm x 80 mm
Board Weight 166 g
Note ...
When additional components are installed, refer
to their operational specifications as this will influ-
ence the modules’ operational and storage tem-
perature.