User guide

Software Setup
55 AT8910/AT8940
www.kontron.com
5.6 Updating the PLD
Updating the FPGA data is done with the "copy" command.
The update package for the FPGA will be delivered as a tar-file and is stored in the data/update path of the
release directory tree.
(BASE Ethernet) #copy tftp://192.168.50.5/t5310-fpga-BETA-1.02.tar pld
Mode........................................... TFTP
Set Server IP.................................. 192.168.50.5
Path........................................... ./
Filename....................................... t5310-fpga-BETA-1.02.tar
Data Type...................................... FW Update
Destination Filename........................... pld
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP Firmware transfer starting...
Firmware update successful...
(BASE Ethernet) #
5.7 Using diagnostics
Diagnostics-software is stored in a separate tar-file which is provided with each release and must be loaded
separately, e.g.
(BASE Ethernet) #copy tftp://192.168.50.5/test-diag.tar backup
Mode........................................... TFTP
Set Server IP.................................. 192.168.50.5
Path........................................... ./
Filename....................................... tes-diag.tar
Data Type...................................... Code
Destination Filename........................... backup
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
TFTP Code transfer starting...
Write image to flash starting...
File transfer operation completed successfully.
(BASE Ethernet) #