Manual

Management Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 6 - 22
Format snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Mode Global Config
6.6.18 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
snmptrap mode <name> <ipaddr>
Mode Global Config
6.6.18.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are inactive (not able
to receive traps).
Format
no snmptrap mode <name> <ipaddr>
Mode Global Config
6.6.19 snmp trap link-status
This command enables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
“snmp-server enable traps linkmode” on page 20.
Format
snmp trap link-status
Mode Interface Config
6.6.19.1 no snmp trap link-status
This command disables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20).
Format
no snmp trap link-status
Mode Interface Config
6.6.20 snmp trap link-status all
This command enables link status traps for all interfaces.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.12 “snmp-server enable traps linkmode” on page 6 - 20
Format
snmp trap link-status all
Mode Global Config
6.6.20.1 no snmp trap link-status all
This command disables link status traps for all interfaces.