Manual

Utility Commands AT8901/2/3
AT8901/2/3 CLI Reference Manual Page 5 - 28
5.7 Keying for Advanced Features
This section describes the commands you use to enter the licence key to access
advanced features. You cannot access the advanced features without a valid license
key.
5.7.1 license advanced
This command enables a particular feature. This command also enables the
corresponding show commands for a feature.
NOTE: If the feature is enabled, the feature is visible in the output of the
show
running-config
command. The <key> parameter specifies the hexa-
decimal key for the feature.
Default none
Format
license advanced <key>
Mode Privileged EXEC
5.7.1.1 no license advanced
This command disables a particular feature. This command also disables the
corresponding show commands. The
<key> parameter specifies the hexadecimal key
for the feature.
Format
no license advanced <key>
Mode Privileged EXEC
5.7.2 show key-features
This command displays the enabled or disabled status for all keyable features.
Format
show key-features
Modes Privileged EXEC
User EXEC
Function This is the name of the keyable component or feature.
Status Enabled or disabled.
5.8 Simple Network Time Protocol (SNTP) Commands
This section describes the commands you use to automatically configure the system
time and date by using SNTP.
image1 image2
Copy image1 to image2.
image2 image1
Copy image2 to image1.
Table 8. Copy Parameters
Source Destination Description